EU Declaration of Conformity / Instructions and Information

1.Check if the mask is in good condition before wearing.

2. Face the side without nose clip and make the nose clip on the top appropriate position.

3. Press the nose clip until it fits well to your nose. Unfold the mask until it fits your face well.

Warning and Information for Use
1. This product is not flame resistant and must not be used in areas with open flames or explosive atmosphere.
2. This product must only be used with in the usage time according to national recommendations.
3. Make sure the mask fits and seals as it is very critical to the performance of the product.
Fit test:
a.Breathe and check with your finger tip and escaping air all around the mask. Adjust the position of the mask until there is no air escaping though the seals on normal breathing.
b.Hang the ear loops behind the ears and ensure they fit well and will not fall.
C.Press the nose clip until it seals as it is close to the both sides of the nose.
4. Facial hair will have a crucial negative impact on the fit and leakage of the product and protection
5. Check before use to confirm the product is not damaged and discard if the checks prior to use are not OK.
6. It is recommended to use the product in a ventilated environment.
7. Low air quality has negative impact on the protection.
8. The filtering half-mask shall be discarded if following situations happen.
a. Use more than recommended time.
b. It is damaged or contaminated.
c. The fit seal is not OK.
9. The filtering half-mask should be discarded if the fit test is not satisfactory.
10. The filtering half-mask should not be used for more than one shift.
Packing :5pcs/ package

Storage: Keep it dry and clean in cool place.(Temperature:0℃~50℃  Humidity: <50%)

Transportation: Prevent from sunlight, rain and snow.
Validity: 2years
Manufacture: Shanghai Dean Electrical Co., Ltd.
Address: Unit B Floor 4 Block A NO.3518 Yunshui Road Pudong New Area Shanghai China.
Tel: +86-21-58387288
Number and version: PPE-R/02.075 version 2 and PPE Regulation 2016/425
Notified party and address: APAVE SUDEUROPE SAS,（module B and C2）
CS60193 – 13322 MARSEILLE CEDEX 16 – France
Manufacture Instruction and information / EU declaration of conformity can be accessed: http://www.dean.com.cn/Eng/news_det.asp?id=110